Machined plastic and nylon parts with plates and gears. Nylon gears are quiet and self-lubricating; machined plastic parts skip tooling cost entirely, which makes them the smart choice between prototype and molding volume.
Function and Design
Gears fail on tooth form and finish. Ours are hobbed or milled then deburred tooth by tooth, and runout is checked against the bore so mesh stays quiet for the life of the gear.
What Makes It Work
- Made to your drawing – this listing shows the family range.
- Deburred edges and clean surfaces on arrival, ready for your line.
- Full documentation set available: material certs, dimensional reports, first article files.
- Material: engineering polymer (nylon / POM / PTFE) – confirmed against your drawing before tooling, so the part matches the print on the first batch.
- Process: the part runs on CNC turning centres, critical faces finished in one setup.
- Finish: No catalogue finish: the part surface is agreed on the drawing and confirmed at sample approval.
- Size: Final dimensions of the part to your drawing; this page shows the family, your version is quoted from the print.
- Custom: Custom part production – samples and first articles precede volume.
Where It Is Used
Production volumes of this part run in automation and robotics hardware, instrumentation fittings, pneumatic and hydraulic systems.
Why Source It From Aunov
Bar-fed cells run unattended for consistency, and any dimension that drifts stops the cell. Inspection is done in a climate-controlled room, and any dimension that drifts stops the machine rather than the shipment.
Send the drawing or a sample and we return a quotation with material advice and lead time.