Anodized aluminum brackets and housings, machined then anodized for a hard, colored, corrosion-proof skin. The anodize builds on the machined surface without changing fit on non-critical dims, and it holds up where raw aluminum would white-spot.
Function and Design
The bracket is small in the bill of materials and large in the warranty claim when it goes wrong. The bracket is produced to print, with the features that carry function inspected first.
What Makes It Work
- Hard anodic finish: colour and corrosion resistance built into the surface.
- Consistent batch quality – first article verified, production sampled against the same dimensions.
- Volume runs are priced against in-house tooling and dedicated capacity.
- Material: Your drawing decides the grade; bracket batches have been run in steel, stainless, aluminium and brass.
- Process: turn-mill machining: the bracket is turned, then cross-drilled and milled to print.
- Finish: Natural as standard, or anodising, colour to spec – logged on the job card so repeats match.
- Size: Size is taken from the customer drawing; the bracket family range gives a starting point for quotation.
- Custom: OEM/ODM to drawing; free samples of the bracket and a manufacturability review before tooling.
Applications
In service you will find this part in electronic and telecom enclosures, pump and valve assemblies, automation and robotics hardware.
Factory-Direct Advantage
Bar-fed cells run unattended for consistency, and any dimension that drifts stops the cell. First articles on the CMM, production sampled against the same dimensions, and dimensional reports with material certs where PPAP levels are required.
Request a quotation and the reply confirms material options, tolerances and tooling cost.